Industrial water treatment chemicals · Manufacturer & global B2B supply[email protected] · +86 177 3480 9172
RYZE Technology logoRYZETECHNOLOGY
APPLICATION

Coal washing

Slime water clarification, thickener underflow and filter cake moisture in coal preparation plants — the chemistry that decides whether the wash water can be recycled.

A coal preparation plant recycles its water, so the flocculant is part of the water balance. Poor clarification sends slime back to the plant, raises ash in the product and eventually forces a shutdown.

What is in the water

ComponentConsequence
Fine coal and clay slimeSlow settling, high turbidity, thickener overload
Residual magnetite (dense medium)Loss with overflow, higher medium consumption
Flotation reagentsFoam in thickener and pumps
High solids load after heavy rainHydraulic and chemical overload

Typical route

  1. Coagulant — PAC 10–40 g/t where clay content is high or the feed is very dilute.
  2. Anionic PAM — 5–40 g/t dry solids, high molecular weight, injected into the thickener feed launder.
  3. Defoamer — silicone emulsion where flotation reagent foam blocks the thickener or the vacuum filter.
  4. Filter aid — the same polymer at reduced dose, or a lower molecular weight grade for disc filters.

Operating notes

  • Control by overflow turbidity and underflow density; the target is usually 25–35% solids for the filter feed.
  • Keep the polymer dilution at 0.05–0.1% and the line short; diluted solution degrades within hours.
  • Magnetic medium recovery benefits indirectly: better clarification means less magnetite in the overflow.
  • In winter, cold water slows floc formation; a slightly higher dose or a warmer make-up stream helps.

What goes wrong

  • Thickener overflow turbid after a rain event — solids load exceeded the hydraulic design; reduce feed rate and raise dose temporarily, then re-tune.
  • Filter cake too wet — floc too fine or the vacuum is inadequate; check dose before changing the filter.
  • Foam in the thickener — flotation reagent residue; a silicone defoamer is the practical fix, dosed into the feed.
  • Polymer cost rising month on month — often clay content in the feed seam, not the product.

Send the feed solids, ash, PSD and current flocculant. We propose a grade and a g/t band for a thickener trial.

Questions buyers ask

Direct answers

Which polymer for coal slime water?

High-molecular-weight anionic PAM in most plants, 5–40 g/t dry solids. Clay-heavy slime usually needs a PAC dose upstream to stop the polymer being consumed by the finest particles.

How do we cut filter cake moisture?

Condition the slurry properly before filtration, keep the floc coarse but not sticky, and check vacuum and cloth condition. Polymer alone cannot compensate for a worn filter.

Can one product handle thickener and filter?

Often yes at different doses, but if the filter blinds, a lower molecular weight grade is the cheaper long-term answer.

Is defoamer necessary?

Only where flotation reagent foam actually interferes. Dosing defoamer everywhere is a cost with no benefit.

Send your water or material data.

We reply with a product route, indicative dosage and the documents you need.

Contact technical sales ↗