Industrial water treatment chemicals · Manufacturer & global B2B supply[email protected] · +86 177 3480 9172
RYZE Technology logoRYZETECHNOLOGY
APPLICATION

Mining & mineral processing

Tailings thickener performance, overflow clarity and recycled water quality — where a flocculant is judged by tonnes per hour and by the clarity of the water going back to the plant.

In a concentrator the flocculant is a production chemical: underdosed, the thickener cannot hold the tonnage and overflow goes turbid; overdosed, the underflow is too viscous to pump and the polymer bill doubles. The operating window is narrower than most suppliers admit.

What decides flocculant performance

FactorEffect
Particle size distributionFine grinding needs higher molecular weight and a coagulant upstream
Clay and slime contentConsumes polymer, slows settling, raises underflow viscosity
pH and lime additionCharge behaviour changes; some systems need coagulant first
Feed densityDilute feed wastes polymer; thick feed channels the floc
Thickener hydraulic loadOverflow clarity collapses before settling rate does
Make-up water qualityHigh salinity changes polymer conformation

Typical route

  1. Coagulant (if needed) — PAC or PFS for clay-heavy or colloidal tailings, 10–50 g/t.
  2. Anionic PAM — high molecular weight (15–25 million), 10–60 g/t of dry solids, diluted to 0.05–0.1% at the injection point.
  3. Filter or press aid — often the same polymer at a lower dose, or a lower molecular weight grade to avoid blinding the cloth.

Doses are grams per tonne of dry solids, not ppm of slurry. Quoting in ppm is a common source of confusion in tender documents.

Operating practice

  • Dilute the stock to 0.05–0.1% before injection; undiluted polymer creates "fish eyes" and wastes 20–30% of the dose.
  • Inject into the feed launder with enough turbulence to disperse but not enough to shear the floc.
  • Control by overflow turbidity and underflow yield stress, not by polymer flow alone.
  • Keep the dosing point close to the thickener; long lines age the diluted solution.

What goes wrong

  • Overflow turbid while underflow is thick — polymer dose is above optimum; reduce and re-test.
  • Underflow will not pump — over-flocculation or too high a molecular weight; drop to a lower molecular weight grade.
  • Polymer consumption jumps after a ore change — clay or slime content rose; a coagulant upstream usually costs less than raising polymer dose.
  • Filter cloth blinds quickly — floc too large or too sticky; adjust molecular weight and dose before changing cloth.

Tell us the solids throughput, PSD, feed density and the current flocculant type. We propose a grade and a g/t starting point for a plant trial.

Questions buyers ask

Direct answers

Which flocculant for tailings thickening?

High-molecular-weight anionic PAM for most mineral tailings. Clay-rich or colloidal tailings usually need a coagulant (PAC/PFS) upstream so the polymer is not consumed by the finest fraction.

What dose should we trial?

10–60 g/t dry solids is the usual band, run as a step test in 5 g/t increments. Measure settling rate, overflow turbidity and underflow yield stress at each step.

Can we use the same polymer for thickening and filtration?

Sometimes, but filtration usually prefers a lower molecular weight or lower dose to avoid cloth blinding. Two grades often cost less overall than one compromise grade.

Why does overflow clarity drop at night?

Feed or water temperature, mill throughput or recycle quality usually change on the night shift. Log turbidity against throughput before blaming the polymer.

Send your water or material data.

We reply with a product route, indicative dosage and the documents you need.

Contact technical sales ↗